TA Triumph-Adler DC 2045 - Manual (Page 200)

Section 7 COPIER MANAGEMENT FUNCTIONS
7-66
3 If you want to change the name of that box, first select “Box
name” and then touch the “Change #” key. Enter the new
name as desired.
Inch specifications
Box007
Box name ABCD_0000101
password (No registrat.)
Default menu Reset
Box
Change #
Close
Default setting - Document Management - Box editting
Setting mode
Metric specifications
BOX 007
Box name ABCD_0000101
Password (No register)
Close
Default menu Reset
Box
Change #
Default setting - Document management - Box editting
Setting mode
NOTE
• Refer to “Entering characters” on page 7-72 for information on
entering characters.
4 If you want to change the name of that box, first select
“Password” and then touch the “Change #” key. The
“Password” screen will be displayed.
5 Use the keypad to enter the new password for that box and
then touch the “Close” key. The new password will be
registered and the touch panel will return to the screen in
step 3.
Inch specifications
password (Enter by #key)
password Back Close
Default setting - Document Management - Box edittings - 077
Enter new password.
Clear
Metric specifications
password (Enter #-key)
Password Back Close
Default settund - Document Management - Box editting - 006
Enter new password.
Clear
NOTES
• The password can be between 1 and 8 digits long.
• If you decide not to register a password for that box, touch the
“Clear” key and then, with nothing entered in the password field,
touch the “Close” key.
6 If you want to delete all of the data in that box, select “Reset
Box”. A verification screen will be displayed.
7 Touch the “Yes” key or the “No” key, as appropriate.
Inch specifications
Box No. :
Box name :
Reset this Box. Do you really want to reset?
Yes No
Stop
007
ABCD_0000101
Metric specifications
BOX NR. :
Box name :
Stop
007
ABCD_0000101
Reset this Box. Do you really want to reset?
Yes No
If you selected “Yes”, all the data in the selected box will be
deleted and the touch panel will return to the screen in step
3.
If you selected “No”, the touch panel will return to the
screen in step 3 without deleting any data.
8 Touch the “Close” key. The touch panel will return to the
screen in step 2.
9 Touch the “Close” [“Job cancel”] key. The touch panel will
return to the screen in step 1. Touch the “Close” key. The
touch panel will return to the “Default setting” screen.Touch
the “End” key. The touch panel will return to the contents of
the “Basic” tab.