Warning, Caution, If paper jams – TA Triumph-Adler DC 2045 User Manual

Page 222

Advertising
background image

Section 9 TROUBLESHOOTING

9-6

3. If paper jams

(1) Cautions

* Do not reuse misfed paper.
* If paper is torn during removal, be sure to remove any loose scraps

of paper from inside the copier, or they could cause another misfeed
later.

* Once misfed paper has been removed, warm-up will begin, the

misfeed indication will go out, and the copier will return to the same
settings prior to the misfeed.

* If a misfeed occurs in the Document Finisher, it is not necessary to

add the misfed copy to the other copies that are already ejected into
the tray, as that copy will be automatically made again.

(2) Removal procedures

1

Misfeed in a paper feed area

Misfeed in drawer[cassette] No.1 or drawer[cassette] No.2
(“JAM 10” or “JAM 11”)

If one of the messages above is displayed, a misfeed has occurred in
the indicated drawer[cassette]. Perform the following procedure to
remove the jammed paper.

Inch specifications

Paper misfeed.

1.Open right cover, and remove paper.
2.Open paper drawer 1.
3.Remove paper.
4.Set the drawer, and close the cover.

JAM 00

Metric specifications

Paper misfeed.

1.Open right cover, and remove paper.
2.Open paper cassette 1.
3.Remove paper.
4.Set the cassette, and close the cover.

JAM 00

1

First, open the right cover and check if there is any jammed
paper. If there is any jammed paper inside that cover,
remove it.

2

Pull out the drawer[cassette] currently being used.

If a paper misfeed occurs, copying will stop and a message will appear on the touch panel about the misfeed. Leave the main switch ON ( | ) and
refer to “(2) Removal procedures” to remove the jammed paper.

Inch specifications

Metric specifications

Paper misfeed.

1.Open front cover.

JAM 00

Paper misfeed.

1.Open front cover.

JAM 00

WARNING

High voltage is present in the charger section. Take
sufficient care when working in this area, as there is
a danger of electrical shock.

CAUTION

The copier’s fixing unit is extremely hot. Take
sufficient care when working in this area, as there is
a danger of getting burned.

Advertising
This manual is related to the following products: