TA Triumph-Adler DC 2045 - Manual (Page 232)

Section 9 TROUBLESHOOTING
9-16
5 Misfeed in the Document Processor
(“JAM 70” through “JAM 76”)
If one of the messages above is displayed, an original has misfed in
the Document Processor. Perform the following procedure to remove
the jammed original.
Inch specifications
Paper misfeed.
1.Open cover of Document processor.
2.Lift reversing unit up.
3.Turn the left dial.
4.Remove original.
5.Close cover of Document processor.
JAM 00
Metric specifications
Paper misfeed.
1.Open cover of Document processor.
2.Lift reversing unit up.
3.Turn the left knob.
4.Remove original.
5.Close cover of Document processor.
JAM 00
1 Remove all of the originals remaining in the original table.
2 Open the Document Processor cover.
3 If there is an original there, remove the jammed original
without tearing it.
* If the original does happen to tear, remove any loose
scraps from inside the Document Processor. Loose scraps
of paper may cause other originals to misfeed.
4 lift open the reversing unit.
5 If there is an original there, remove the jammed original
without tearing it.
* If the original does happen to tear, remove any loose
scraps from inside the Document Processor. Loose scraps
of paper may cause other originals to misfeed.
6 Turn the original feed dial to feed any misfed original out to a
location that makes it easier to remove.
7 Close the Document Processor cover.
6 Misfeed in the optional Document Finisher
(“JAM 80” through “JAM 95”)
If a misfeed occurs in the Document Finisher, refer to the Operation
Guide for your Document Finisher and remove the jammed paper
accordingly.