TA Triumph-Adler DC 2045 - Manual (Page 219)

Section 9 TROUBLESHOOTING
9-3
Message
“Exceeds pre registered copying
quantity.” [“Copy limit for this ID-
code has been reached.”]
“Ready to copy. Add toner.”
“Add toner to resume copying.”
“Image cycle.” [“Now adding toner.”]
“Cannot use this paper for copying.”
“Turn off the main SW, and wait ten
seconds, then turn it on again.”
[“Turn off the main switch for 10
seconds then turn it on again.”]
“System error. Main switch off / on.”
“Disconnect power plug from the
socket.”
“Call service.”
“Time for maintenance”
“Check KMAS.”
“Time for replacing Felt Roller.”
[“Felt cleaning maintenance.”]
“Call for service to replace Felt
Roller.” [“Change felt clean.-(F.unit)”]
“Insert key counter.”
“Memory full.”
“Paper misfeed. Remove paper.”
“Attach Side Paper Deck to
Mainframe.”
[“Attach side feeder to main frame.”]
“Paper capacity exceeded. Remove
paper from Side Paper Deck.”
[“Paper capacity exceeded. Remove
paper from side feeder.”]
“Finisher is out of order. Press
“Continue” to resume job”
Procedure
The number of copies made under your department ID-code has reached the limit that
was set under the copy management mode and copying is no longer possible with that
code. Use the copy management mode to clear the copy count.
There is insufficient toner left in the copier. Since only one copy can be made at a time in
this state, add toner as soon as possible.
There is insufficient toner left in the copier to make copies. Add toner immediately.
Toner is now being added. Please wait until the operation is complete.
Copying is not possible at the currently selected sizes.
An error has occurred. Turn the main switch OFF (O), wait about 10 seconds and then
turn the main switch back ON ( | ) again.
An error has occurred. Turn the main switch OFF (O) and then back ON ( | ) again.
An error has occurred. Remove the power plug from the outlet.
Open and then close the front cover. If this message still remains, make a note of the
number that displayed with the “C”, turn the main switch OFF (O), remove the power
plug from the outlet and contact your service representative or authorized service center.
Periodic maintenance is required to keep your copier in good condition. Contact your
service representative or authorized service center as soon as possible.
An error has occurred. Contact your service representative or authorized service center.
It is time to replace certain parts in your copier. Contact your service representative or
authorized service center.
It is time to replace certain parts in your copier. Contact your service representative or
authorized service center.
Insert the Key Counter securely into its opening.
The copier's memory is full. Select whether you want to print out that data that is already
scanned or delete all of that data. It will not be possible to copy or scan another original
until one of these two operations is performed.
If paper misfeeds, the location of the misfeed will be indicated on the touch panel. Leave
the main switch ON ( | ) and follow the appropriate procedure to remove the jammed
paper.
Attach the optional Side Feeder securely to the copier.
The number of sheets of paper loaded in the optional Side Feeder has exceeded the
acceptable limit. Load paper only up to the acceptable limit.
The optional Document Finisher is out of order and cannot be used for the moment.
Contact your service representative or an authorized service center as soon as possible.
Reference
page
7-8
3-8
3-8
—
—
—
—
—
—
—
—
—
—
8-7
—
9-6
—
3-5
—