4 wiring the power input – PLANET IGS-10020HPT User Manual
Page 36
Advertising
User’s Manual of IGS-10020HPT
2.1.4 Wiring the Power Input
The 6-contact terminal block connector on the rear panel of IGS-10020HPT is used for two DC redundant powers input. Please
follow the steps below to insert the power wire.
1.
Insert positive / negative DC power wires into the contacts 1 and 2 for DC POWER 1, or 5 and 6 for DC POWER 2.
Figure 2-3: IGS-10020HPT
Upper Panel
2.
Tighten the wire-clamp screws for preventing the wires from losing.
1 2
3 4 5
6
DC
1 DC
2
+ - +
-
Figure 2-4
6-Pin Terminal Block Power Wiring Input
36
Advertising