6 wiring the digital input / output – PLANET IGS-10020HPT User Manual
Page 38
Advertising
User’s Manual of IGS-10020HPT
2.1.6 Wiring the Digital Input / Output
The 6-contact terminal block connector on the rear panel of IGS-10020HPT is used for Digital Input and Digital Output. Please
follow the steps below to insert wire.
1.
IGS-10020HPT offers two DI and DO groups. 1 and 2 are DI groups, 3 and 4 are DO groups and 5 and 6 are GND
(ground).
Figure 2-5
Wiring the Redundant Power Inputs
2.
Tighten the wire-clamp screws for preventing the wires from loosing.
1 2 3 4 5 6
DI0 DI1
DO0 DO1 GND GND
Figure 2-6
6-Pin Terminal Block DI / DO Wiring Input
38
Advertising