3 wall mount plate mounting – PLANET IGS-10020HPT User Manual
Page 44
User’s Manual of IGS-10020HPT
2.2.3 Wall Mount Plate Mounting
To install the Industrial Managed Switch on the wall. Please follow the instructions below.
As following all DIN-Rail installation steps we use an example device to show how we install
DIN-Rail kit, procedure of the IGS-10020HPT is same as the example device.
Step 1:
Remove the DIN-Rail from the Industrial Managed Switch. Use the screwdriver to loose the screws and remove the
DIN-Rail.
Step 2:
Place the wall mount plate on the rear panel of the Industrial Managed Switch.
Step 3:
Use the screwdriver to screw the wall mount plate on the Industrial Managed Switch.
Step 4:
Use the hook holes at the corners of the wall mount plate to hang the Industrial Managed Switch on the wall.
Step 5:
To remove the wall mount plate, reverse steps above.
44