ProSoft Technology MVI94-DNP - Manual (Page 102)

Reference MVI94-DNP ♦ Flex I/O
User Manual DNP 3.0 Server over Ethernet Communication Module
Page 102 of 131 ProSoft Technology, Inc.
December 17, 2010
Variable
Name Data Range Description IF Error Config.
Value
Initialize IED
Database:
Y or N This parameter defines if the BI/AI/C data
will be transferred from the processor to
the module before normal data transfer
occurs. Set the parameter to N to not use
the feature. Set the parameter Y to use
the feature. The use of this feature
requires ladder logic to transfer the data.
N
Variable
Name Data Range Description IF Error Config.
Value
[IED
Database]
This section header defines the start of the DNP master parameter
set.
Binary Inputs: 0 to 960 Number of binary input points contained in
the IED database to transfer to the PLC
and obtained from the attached IED units..
0
Binary
Outputs:
0 to 960 Number of binary output points contained
in the IED database which are transferred
from the PLC and used by the attached
IED units..
0
Counters: 0 to 30 Number of counter points contained in the
IED database to transfer to the PLC and
obtained from the attached IED units..
0
Analog
Inputs:
0 to 120 Number of analog input points contained
in the IED database to transfer to the PLC
and obtained from the attached IED units..
0
Analog
Outputs:
0 to 60 Number of analog output points contained
in the IED database which are transferred
from the PLC and used by the attached
IED units..
0
Variable
Name Data Range Description
[DNP Master
Slave List]
This section header defines the location of the DNP master slave
definition list.
# DL Conf Mode ==> 0=Never, 1=Sometimes and 2=Always (select 0).
# Flag parameter is bit coded as follows:
# Bit 0 (decimal 1) ==> Enable the slave
# Bit 1 (decimal 2) ==> Use Unsolicited messaging with this slave
# Bit 2 (decimal 4) ==> Use delay measurement with this slave
# Bit 3 (decimal 8) ==> Auto time synchronization enabled
START This string signals the start of the slave definition list.
# Node DL Conf Conf Conf App Rsp
# Address Mode Timeout Retry Timeout Flags
2 0 1000 0 5000 9
END This string signals the end of the slave definition list.