ProSoft Technology MVI94-DNP - Manual (Page 23)

MVI94-DNP ♦ Flex I/O Configuration
DNP 3.0 Server over Ethernet Communication Module User Manual
ProSoft Technology, Inc. Page 23 of 131
December 17, 2010
3.2 [Module]
The [MODULE] section defines if the module will emulate a DNP master or slave
device.
The following table describes the parameters in this section.
Variable Name Data Range Description IF Error
[Module] This section header indicates the start of
the module specific parameter set.
Module Name: 80 Characters This parameter sets the name or
description of the module's application
"Not Configured"
Type: M=Master or
S=Slave
This parameter must be set to M for the
DNP port to use as a master port. If the
parameter is set to any other value, the
port will be used as a slave port.
S