ProSoft Technology MVI94-DNP - Manual (Page 24)

Configuration MVI94-DNP ♦ Flex I/O
User Manual DNP 3.0 Server over Ethernet Communication Module
Page 24 of 131 ProSoft Technology, Inc.
December 17, 2010
3.3 [DNP Slave]
The [DNP SLAVE] section is only required if the module is emulating a slave
device. This section contains the information required to configure the
communication port and set the protocol specific parameters. Refer to the
configuration form (page 95) for a complete list of the parameters set in this
section.