ATEN KN Series 32-Port KVM over IP Switch with Dual Power/LAN (1-Local + 4-Remote Access) - Manual (Page 142)

KVM over IP Switch User Manual
124
The port access settings are explained in the following table:
Name Each port accessible to the user is listed under the Names
column.
Access The Access column is where device access rights are set. To
cycle through the choices, click the icon in the row that
corresponds to the user you want to configure. The meanings of
the icons are as follows
Full Access
The user can view the remote screen
and can perform operations on the
remote server from his keyboard and
monitor.
View Only
The user can only view the remote
screen; he cannot perform any
operations on it.
No Access
No access rights - the Port will not show
up on the User's list on the Main Screen.
Mount USB The Mount USB column is where permission to mount Virtual
Media devices on remote servers is configured. To cycle through
the choices, click the icon in the row that corresponds to the user
you want to configure. The icons are the same as the ones in the
Access column.
Š
With a Full Access setting, the user can mount, read, and write
to the virtual media.
Š
With a View Only setting, the user can only view the contents of
the virtual media (read only), he can not perform any operations
on it.
Š
With a No Access setting, the user will not see the virtual media
even if it has been configured on the remote system.
Note: This entry does not appear for switches that do not support
the USB Virtual Media function.
Config Sets or denies permission for the user to make changes to a
port’s configuration settings. A check mark (
√
) indicates that the
user has permission; an X means that the user does not have
permission.
PON The PON column permits/restricts the configuration and power
operation of ports that have Power Over the Net™ devices
connected to them. A check mark (
√
) indicates that the user has
permission; an X means that the user does not have permission.