ATEN KN Series 32-Port KVM over IP Switch with Dual Power/LAN (1-Local + 4-Remote Access) User Manual
Page 154
KVM over IP Switch User Manual
136
3. Configure the outlet according to the information provided in the
following table:
Note:
If there is a conflict between the day set in the Period panel and
the time the operation is supposed to start, a message will appear
informing you of the problem. Click the
Date/Time
button and
reset the time and date.
4. When you have finished making your configuration settings, click
Save
.
5. Repeat the above steps to set up additional schedules.
To modify a schedule, select it in the main panel, then click
Modify
.
The
Outlet Schedule
dialog box comes up – make your changes, then
click
Save
.
To delete a schedule, select it in the main panel, then click
Remove
.
To run all power operations listed in the
Outlet Schedule
dialog box
now – without waiting for the scheduled time to arrive – click
Run
.
To stop all power operations listed in the
Outlet Schedule
dialog box,
click
Stop
.
Synchronization
If more than one outlet has been selected for association with a port,
Synchronization
can be used to standardize their configurations.
Enabling
Synchronization
(by checking the checkbox), brings up the
Pon Outlet Configuration
dialog box (see
The settings that you make are applied to all the outlets associated with
the port so that their settings are all the same, and all the outlets
associated with the port have the same schedule configuration as the
first PON outlet.
Field
Explanation
Schedule Name Provide a name to identify the scheduled operation by.
Operation
Mode
Select the type of power operation you want to occur at the
scheduled time.
Period
Select the time period that the scheduled operation will occur
at: Once; Weekdays; or Daily – then drop down the list to
select which day the operation is to start on.
Time
Click the
Date/Time
button to select the time and date the
operation is to start on.