ATEN KN Series 32-Port KVM over IP Switch with Dual Power/LAN (1-Local + 4-Remote Access) - Manual (Page 57)

39
Chapter 3
Super Administrator Setup
Overview
This chapter discusses the administrative procedures that the Super
Administrator performs to get the KVM over IP switch set up for the first time.
First Time Setup
Once the KVM over IP switch has been cabled up, the Super Administrator
needs to set the unit up for user operation. This involves setting the network
parameters, and changing the default Super Administrator login. The most
convenient way to do this for the first time is from the local console.
Note: For remote methods of setting up the network, see IP Address
Determination , page 256.
After the local console has been connected (see Single Stage Installation ,
page 27), and the KVM over IP switch turned on, a login prompt appears on
the console monitor:
Since this is the first time you are logging in, use the default Username:
administrator ; and the default Password: password .
Note: For security purposes, you should change these to a unique Username
and Password. (See
Changing the Super Administrator Login , page 42
for details.)