ATEN KN Series 32-Port KVM over IP Switch with Dual Power/LAN (1-Local + 4-Remote Access) - Manual (Page 275)

Appendix
257
3. Select the KVM over IP switch in the Device List .
Note: 1. If the list is empty, or your device doesn't appear, click
Enumerate to refresh the Device List.
2. If there is more than one device in the list, use the MAC address
to pick the one you want. The KVM over IP switch’s MAC
address is located on its bottom panel.
4. Select either Obtain an IP address automatically (DHCP) , or Specify an
IP address . If you chose the latter, fill the IP Address, Subnet Mask, and
Gateway fields with the information appropriate to your network.
5. Click Set IP .
6. After the IP address shows up in the Device List, click Exit . See IP
Installer , page 160 for more information.
Browser
1. Set your client computer's IP address to 192.168.0. XXX
Where XXX represents any number or numbers except 60. (192.168.0.60 is
the default address of the KVM over IP switch.)
2. Specify the switch's default IP address (192.168.0.60) in your browser, and
you will be able to connect.
3. Assign a fixed IP address for the KVM over IP switch that is suitable for
the network segment that it resides on.
4. After you log out, reset your client computer's IP address to its original
value.