ATEN KN Series 32-Port KVM over IP Switch with Dual Power/LAN (1-Local + 4-Remote Access) - Manual (Page 27)

Chapter 1. Introduction
9
KVM Adapter Cables
Š
Cat 5e (or higher) cable is required to connect the KVM over IP switch to
the KVM Adapter Cables (see page 27).
Š
The following KVM Adapter Cables are required for use with the KVM
over IP switch:
Note: If you use Adapter Cables purchased prior to your switch purchase, you
may have to upgrade the Adapter’s firmware. (see page 200).
Function Module
Connect to devices with PS/2 ports KA7120
Connect to devices with USB ports
(All platforms – PC, Mac, Sun) KA7170
Connect to Sun Legacy Computers KA7130
Connect to serial based devices KA9140 / KA7140
For USB computers – DVI output, Virtual
Media and Smart Card Reader support KA7166
For USB computers – HDMI output, Virtual
Media and Smart Card Reader support KA7168
For USB computers – DisplayPort output,
Virtual Media and Smart Card Reader support KA7169
Connect to devices with USB ports and virtual
media support KA7175
Connect to devices with USB ports, virtual
media and audio support KA7176
Connect to devices with USB ports, with virtual
media, smart card reader support KA7177