Fujitsu Ricoh Fujitsu fi-7300NX Color Duplex Document Scanner - Manual (Page 110)

When using the Software Operation Panel, refer to Setting to Ignore Certain Overlap Patterns [Intelligent
Multifeed Function] (page 299) .
Operational Procedure
1 If [Multifeed detected (Overlap)] (error code: "J2:55") is displayed on the touch screen, either press the
[Eject Document] button to eject the document from the paper path or open the ADF to remove the
document.
For details, refer to
How to Open the ADF (page 63) .
CAUTION
When the ADF is open, it might close accidentally. Be careful not to get your fingers
caught.
2 If you open the ADF to remove the document, close it.
For details, refer to
How to Close the ADF (page 64) .
CAUTION
Be careful not to get your fingers caught when closing the ADF.
ATTENTION
Confirm that the ADF is closed properly. Otherwise, documents may not be fed into the ADF.
3 Load the removed document back in the ADF paper chute (feeder).
4 Respond to a message that is displayed in the touch screen.
The following settings can be configured depending on the operation mode that is set in the [Intelligent
Multifeed Detection] screen.
● For [Manually Bypass]
- [Disable the multifeed detection for the next document]
Select whether to detect overlapped documents for the next scan.
- [Keep Multifeed Images]
Select whether to save the image when overlapped documents are detected.
This may not be displayed depending on the scanner driver settings.
● For [Automatically Bypass (combination of length and position)]
- [Memorize Patterns]
Select whether you set the scanner to memorize the paper overlapping patterns.
- [Keep Multifeed Images]
Select whether to save the image when overlapped documents are detected.
This may not be displayed depending on the scanner driver settings.
● For [Automatically Bypass (length)]
- [Memorize Patterns]
Various Ways to Scan
110