Fujitsu Ricoh Fujitsu fi-7300NX Color Duplex Document Scanner User Manual
Page 264
Setting Item
Description
Configure the settings to detect overlapped documents during a
scan.
Configure the settings to fill in the shadow or streaks around
the edge of the scanned image.
You can exclude a color from being scanned by selecting either
red, green, or blue (three primary colors).
Enable this to shorten the scanning time when scanning
continuously.
Document check area specification for
Multifeed Detection
Specify an area to detect overlapped documents.
Intelligent Multifeed Function
Configure the setting to automatically ignore certain patterns of
overlapped documents when the setting to detect overlapped
documents is enabled.
Number of paper feeding retries
Specify the number of feeding retries when a document is not
fed from the ADF paper chute (feeder).
Specify the cleaning cycle for the scanner inside.
Specify the replacement cycle for the consumables.
You can configure the settings for detecting dirt on the glass.
Specify the sensitivity level to detect vertical streaks (dirt on the
glass) when [Enable] is selected for [Vertical Streak Detection].
You can specify the timing of when document feeding is started.
When the scanner is set to detect the paper size automatically,
specify whether or not to optimize (round up/down) the
fractional part of the scanned image.
Configure the settings when manually loading and scanning
one sheet at a time.
Specify whether or not to turn on/off the scanner by pressing
the [Power] button on the scanner.
Configure the setting to detect feeding errors.
Specify the sensitivity level for detecting feeding errors when
the paper protection function is enabled.
Maintenance and Inspection Cycle
Specify the maintenance and inspection cycle for the scanner
that is performed by a service engineer.
Enable this mode to use the scanner at an altitude of 2,000 m
or higher.
Scanner Settings (Software Operation Panel)
264