Fujitsu Ricoh Fujitsu fi-7300NX Color Duplex Document Scanner - Manual (Page 233)

- When a piece of paper is attached on a document, the length and position of the paper can be
memorized, and set to ignore overlapping of documents.
Set it in [Intelligent Multifeed Detection].
● Check Length
Detects overlapped documents according to the difference in length.
Select this to scan documents of the same length.
Note that overlapped documents cannot be detected accurately when a mixed batch of different
lengths are scanned.
● Check Overlapping and Length
Detects overlapped documents by the combination of [Check Overlapping (Ultrasonic)] and [Check
Length].
When this is selected, you can specify the following two options:
- Specify an area to detect overlapped documents by the length from the leading edge of the
document in the feeding direction.
Set it in [Multifeed Detection Area].
- When a piece of paper is attached on a document, the length and position of the paper can be
memorized, and set to ignore overlapping of documents.
Set it in [Intelligent Multifeed Detection].
Note that overlapped documents cannot be detected accurately when a mixed batch of different
lengths are scanned.
Threshold (Length)
Specify the difference in length of documents to be detected as overlapped documents.
Overlapped documents are detected when the the difference in length of documents is longer than
the specified value.
Specify this item when [Check Length] or [Check Overlapping and Length] is selected for [Detection
Method].
Any length under the specified value is tolerated as a slight error and not detected as overlapped
documents.
● 10 mm or less is not detected
This is the factory default setting.
● 15 mm or less is not detected
● 20 mm or less is not detected
ATTENTION
● To scan documents with different lengths, select [Check Overlapping (Ultrasonic)].
● When an attachment such as a sticky note, receipt, or photo is attached on the document, the
attachment part of the document may be detected as overlapping of documents if [Check
Overlapping (Ultrasonic)] is selected. In that case, select [Check Length].
Otherwise, detect overlapping of documents by specifying an area on the document that does not
include an area attached with paper in order to ignore the overlapping of documents for that area.
Scanner Settings (Touch Screen)
233