Fujitsu Ricoh Fujitsu fi-7300NX Color Duplex Document Scanner - Manual (Page 212)

A Shadow Appears at the Top or the Bottom of the Image
Check the following points
● Have you adjusted the offset (position to start the scan)? (page 212)
● Did you use the page edge filler function to fill in the shadow around the edge? (page 212)
If the problem persists, check the items in Before You Contact the Scanner Service Provider (page 217)
first, then contact the distributor/dealer where you purchased this product. Refer to the contact
information in the Contact List if supplied with this product, or refer to the contact information in the
Contact for Inquiries section if provided in Safety Precautions supplied with this product, and then make an
inquiry.
●
Have you adjusted the offset (position to start the scan)?
Solution
In the [Offset] screen on the touch screen, adjust the offset for [Sub-scan ADF front] and [Sub-scan ADF
back].
The [Offset] screen can be displayed in the following procedure:
→ [Scanner Settings] → [Image] → [Offset]
When using the Software Operation Panel, refer to Adjusting the Position to Start the Scan [Offset Setting/
Vertical magnification Adjustment] (page 272) .
●
Did you use the page edge filler function to fill in the shadow around the edge?
Solution
In the [Page Edge Filler Area] screen on the touch screen, fill in the shadow around the edge.
The [Page Edge Filler Area] screen can be displayed in the following procedure:
→ [Scanner Settings] → [Image] → [Page Edge Filler Area]
When using the Software Operation Panel, refer to Removing Shadows/Streaks that Appear around Edges
of Images [Page Edge Filler (ADF)] (page 275) .
For the settings in the scanner driver, refer to the scanner driver's Help.
Troubleshooting
212