Multi-Tech Systems MULTIVOIP MVP-2410 - Manual (Page 127)

MultiVOIP User Guide Technical Configuration (Digital Voips)
127
Local Configuration Procedure (Detailed)
You can begin the configuration process as a continuation of the MultiVOIP
software installation. You can establish your configuration or modify it at any
time by launching the MultiVOIP program from the Windows Start menu.
1. Check Power and Cabling. Be sure the MultiVOIP is turned on and
connected to the computer via the MultiVOIP’s Command Port (DB9
connector at computer’s COM port; RJ45 connector at MultiVOIP).
You must allow the MultiVOIP to finish booting before you launch the
MultiVOIP Configuration Program. The RED boot LED turns itself off
when the booting process is completed.
2. Start MultiVOIP Configuration Program. Launch the MultiVOIP
program from the Windows Start menu (from the folder location determined
during installation).