Multi-Tech Systems MULTIVOIP MVP-2410 - Manual (Page 243)

MultiVOIP User Guide Technical Configuration (Analog/BRI)
243
The SNMP Parameter fields are described in the table below.
SNMP Parameter Definitions
Field Name Values Description
Enable SNMP
Agent Y/N Enables the SNMP code in the firmware
of the
MultiVOIP . This must be
enabled for the MultiVOIP to
communicate with and be controllable
by the
MultiVoipManager software.
Default: disabled
Trap Manager Parameters
Address 4 places; n.n.n.n
n = 0-255 IP address of MultiVoipManager PC.
Community
Name -- A “community” is a group of VOIP
endpoints that can communicate with
each other. Often “public” is used to
designate a grouping where all end users
have access to entire VOIP network.
However, calling permissions can be
configured to restrict access as needed.
Port Number 162 The default port number of the SNMP
manager receiving the traps is the
standard port 162.
Community
Name 1 Length = 19
characters (max.)
Case sensitive. First community grouping.
Permissions Read-Only,
Read/Write
If this community needs to change
MultiVOIP settings, select Read/Write.
Otherwise, select Read-Only to view
settings.
Community
Name 2 Length = 19
characters (max.)
Case sensitive. Second community grouping
Permissions Read-Only,
Read/Write
If this community needs to change
MultiVOIP settings, select Read/Write.
Otherwise, select Read-Only to view
settings.