Multi-Tech Systems MULTIVOIP MVP-2410 - Manual (Page 156)

Technical Configuration (Digital Voips) MultiVOIP User Guide
156
E1 Parameter Definitions (cont’d)
ISDN Parameters
Field Name
Values Description
Enable
ISDN-PRI Y/N If digital connection is ISDN-PRI
type, this box should be checked.
When ISDN is enabled, the “CAS
Protocols” field is grayed out
(ISDN has its own signaling
method).
Terminal/
Network either “Terminal”
or “Network” When “Terminal” is selected, it
indicates that the MultiVOIP
should emulate the subscriber
(terminal) side of the digital
connection. When “Network” is
selected, it indicates that the
MultiVOIP should emulate the
central office (network) side of the
digital connection.
Setting used for MultiVOIP must
be opposite to the setting used in
the PBX. For example, if the PBX
is set to “Terminal,” then the
MultiVOIP must be set to
“Network.”
Country see table, later this
chapter Country in which MultiVOIP is
operating with ISDN.
Operator see table, later this
chapter Indicates phone switch
manufacturer/model or refers to
telco so as to specify the switching
system in question. ISDN is
implemented somewhat differently
in different switches.
Note on Country
& Operator
options. __ [ISDN implementation options are
shown, arranged by country, in a
table below – soon after E1
Parameter Definitions.]