Multi-Tech Systems MULTIVOIP MVP-2410 - Manual (Page 101)

MultiVOIP User Guide Mechanical Installation
101
Cabling Procedure for MVP-410ST/810ST
Cabling involves connecting the MultiVOIP to your LAN and telephone
equipment.
1. Connect the power cord supplied with your MultiVOIP to a live AC outlet
and to the power connector on the back of the MultiVOIP as shown at top
right in Figure 3-12.
Ethernet Connection
Command Port Connection
COMMAND ETHERNET
10 BASET
TERMINAL
MODE
ISDN-B RI Connections
ISDN1 & ISDN 2 : MVP410ST/810ST
ISDN3 & ISDN 4: MVP810ST only
IS DN 1 ISD N2 IS DN 3 ISD N4
?
NETWORK
MODE
ISDN
TA
PBX
PSTN
NT1
Device
*
* NT1 Device is needed
if PBX has “U” interface.
Figure 3-12: Cabling for MVP-410ST/810ST
2. Connect the MultiVOIP to a PC by using a DB-25 (male) to DB-9 (female)
cable. Plug the DB-25 end of the cable into the Command port of the
MultiVOIP and the other end into the PC serial port. See Figure 3-12.
3. Connect a network cable to the ETHERNET 10BASET connector on the
back of the MultiVOIP. Connect the other end of the cable to your network.