MITSUBISHI ELECTRIC FR-S520 - Manual (Page 54)

45
2
Chapter 1
Chapter 2
Chapter 3
Chapter 4
This chapter explains the "functions" for use of this product. For
simple variable-speed operation of the inverter, the factory settings
of the parameters may be used as they are. Set the necessary
parameters to meet the load and operational specifications. Refer
to the instruction manual (basic) for the operation procedures.
Always read the instructions before using the functions.
2.1 Function (Parameter) List ........................................................46
2.2 List of Parameters Classified by Purpose of Use ....................56
2.3 Explanation of Functions (Parameters) ...................................58
2.4 Output Terminal Function Parameters ....................................78
2.5 Current Detection Function Parameters ..................................80
2.6 Display Function Parameters ..................................................82
2.7 Restart Operation Parameters ................................................84
2.8 Additional Function Parameters ..............................................86
2.9 Terminal Function Selection Parameters ................................88
2.10 Operation Selection Function Parameters ............................91
2.11 Auxiliary Function Parameters ............................................109
2.12 Calibration Parameters........................................................111
2.13 Clear Parameters ................................................................115
2.14 Communication Parameters (Only for the Type
Having the RS-485 Communication Function)....................116
2.15 Parameter Unit (FR-PU04) Setting......................................133
CAUTION
As the contact input terminals RL, RM, RH, STR, open collector
output terminal RUN and contact output terminals A, B, C can be
changed in functions by parameter setting, their signal names
used for the corresponding functions are used in this chapter
(with the exception of the wiring examples). Note that they are not
terminal names.
REMARKS
Parameter copy
Use of the parameter unit (FR-PU04) with the type having the
RS-485 communication function allows the parameter values to
be copied to another inverter (only the FR-S500 series).
After batch-reading the parameters of the copy source inverter,
you can connect the parameter unit to the copy destination
inverter and batch-write the parameters.
For the operation procedure, refer to the instruction manual of the
parameter unit (FR-PU04).
2. FUNCTIONS