Sony Ericsson TT4031 (SE-GM29) - Manual (Page 101)

Owner’s Manual Rev 1.0 Page 101 of 101
Display currently
set profile
AT*E2APR?
•_ *E2APR: current <prnum>
•_ ERROR
Shows if the
command is
supported
AT*E2APR=?
•_ *E2APR: (list of supported
<op>s), (list of supported
<prnum1>s), (list of supported
<prnum2>s)
•_ ERROR
This command allows the maniuplation and storage of the audio “profiles”
stored in the MS. The requirement for the 2nd and 3rd parameters depend on
the operation being carried out.
Using the command you can:
Set one of the three audio profiles 0, 1 or 2 as the current profile.
This will load the profile's settings from NVM and implement them.
Read one of the audio profiles. The current settings for the profile
number defined will be displayed.
Copy all parameters from one profile into another.
Reset any of the profiles. This will reinstate the factory defaults for
the profile:
0 is the handset profile,
1 is the portable handsfree profile,
2 is the car kit profile.
Set a profile as the default profile on next power up.
•_
<op> Description
0 Set profile <prnum1> to set as current
1 Copy profile <prnum1> to <prnum2>
2 Read profile <prnum1> settings
3 Reset profile <prnum1> to factory default
4 Set default profile as <prnum1>. Will store this as
defautl profile in NVM, and use it as default from next
power on
•_
<prnum1>,
<prnum2> Description
0 Profile 0 (Factory profile set for handset). Default value
1 Profile 1 (Factory profile set for portable handsfree)
2 Profile 2 (Factory profile set for car kit)