8 atz reset to default configuration – Sony Ericsson TT4031 (SE-GM29) User Manual
Page 144
Owner’s Manual
Rev 1.0
Page 144 of 144
0
Display numeric result codes
1
Display verbose result codes. Default value
List of result codes
ATV1/ATV=1 ATV0/ATV=0
Description
OK
0
Acknowledges execution of a command
CONNECT
1
A connection has been established; the
DCE is moving from command state to
online data state
RING
2
The DCE has detected an incoming call
signal from the network
NO CARRIER
3
The connection has been terminated or
the attempt to establish a connection
failed
ERROR
4
Command not recognized, command
line maximum length exceeded,
parameter value invalid, or other
problem with processing the command
line
NO DIALTONE
6
No dial tone detected
BUSY
7
Engaged (busy) signal detected
NO ANSWER
8
“@” (Wait for Quiet Answer) dial
modifier was used, but remote ringing
followed by five seconds of silence was
not detected before expiration of the
connection timer
CONNECT
<TEXT>
Manufacturer-
specific
Same as CONNECT, but includes
manufacturer-specific text that may
specify DTE speed, line speed, error
control, data compression, or other
status
10.8 ATZ Reset to Default Configuration
Description Command Possible
Responses
Execute
ATZ
•_ OK
•_ ERROR
Execute ATZ=<profile>
•_ OK
•_ ERROR