3 ats2 escape sequence character – Sony Ericsson TT4031 (SE-GM29) User Manual
Page 72
Owner’s Manual
Rev 1.0
Page 72 of 72
<rcnt> Description
0
Disable automatic answer. Default value
1-7
Answer after the specified number of rings
3.3 ATS2 Escape Sequence Character
Description Command Possible
Responses
Set escape sequence
character
ATS2=[<esc>]
•_ OK
•_ ERROR
Read the current setting ATS2 <esc>
Show if the command is
supported
ATS2=?
S2: (list of supported
<esc>s)
Defines the character to be used as the escape sequence character when
switching from on-line data mode to on-line command mode. The response to
the command is modified to reflect the change.
<esc> Description
43
Escape sequence character. Default value
0 to 255
Escape sequence character
NOTE! - If the <esc> parameter is set to a value in the
range of 128-255, the escape sequence detection is
disabled.