8 at+cgqreq quality of service profile (requested) – Sony Ericsson TT4031 (SE-GM29) User Manual
Page 123
Owner’s Manual
Rev 1.0
Page 123 of 123
14
1 000 000 (~2.2 kbits/s)
15
2 000 000 (~4.4 kbits/s)
16
5 000 000 (~11.1 kbits/s)
17
10 000 000 (~22 kbits/s)
18
20 000 000 (~44 kbits/s)
31
50 000 000 (~111 kbits/s)
6.8 AT+CGQREQ Quality of Service Profile (Requested)
Description Command
Possible
Responses
Set quality of
service profile
+CGQREQ=[<cid>
[,<precedence>
[,<delay>
[,<reliability>
[,<peak>
[,<mean>]]]]]]
•_ +CME ERROR: <err>
•_ OK
•_ ERROR
Read the
command
+CGQREQ?
•_ +CGQREQ: <cid>, <precedence>,
<delay>, <reliability>, <peak>,
<mean>[<CR><LF>+CGQREQ:
<cid>, <precedence>, <delay>,
<reliability>, <peak>, <mean>[…]]
•_ OK
•_ ERROR
Test if the
command is
supported
+CGQREQ=?
•_ +CGQREQ: <PDP_type>,
(list of supported <precedence>s),
(list of supported <delay>s),
(list of supported <reliability>s),
(list of supported <peak>s),
(list of supported <mean>s)
[<CR><LF>+CGQREQ:
<PDP_type>, (list of supported
<precedence>s), (list of supported
<delay>s),
(list of supported <reliability>s),
(list of supported <peak>s),
(list of supported <mean>s)[…]]
•_ OK
•_ ERROR
Allows the TE to specify a quality of service profile that is used when the MS
sends an activate PDP context request message to the network.
The set command specifies a profile for the context identified by the (local)
context identification parameter, <cid>. Since this is the same parameter