17 at*e2nbts ericsson m2m neighbour bts – Sony Ericsson TT4031 (SE-GM29) User Manual
Page 174
Owner’s Manual
Rev 1.0
Page 174 of 174
11.17 AT*E2NBTS
Ericsson M2M Neighbour BTS
Description Command
Possible
Responses
Set Neighbour
Cells to monitor
AT*E2NBTS=<ch1>,<bsic1>[,<c
h2>,<bsic2>[,<ch3>,<bsic3>[,
<ch4>,<bsic4>[,<ch5>,<bsic5>
[,<ch6>,<bsic6>[,<ch7>,<bsic7
>[,<ch8>,<bsic8>[,<ch9>,<bsi
c9>[,<ch10>,<bsic10>[,<ch11
>,<bsic11>[,<ch12>,<bsic12>[
,<ch13>,<bsic13>[,<ch14>,<bs
ic14>[,<ch15>,<bsic15>[,<ch1
6>,<bsic16>]]]]]]]]]]]]]]]
•_ ERROR
•_ OK
Read the
monitored
neighbour cells
AT*E2NBTS?
•_ *E2NBTS:
<mcc>,<mnc>,
<ci>,<bsic>,<ch>,
<rxl><CR><LF>
<mcc>,<mnc>,
<ci>,<bsic>,<ch>,
<rxl><CR><LF>
…
<mcc>,<mnc>,
<ci>,<bsic>,<ch>,
<rxl><CR><LF>
<CR><LF>
•_ OK
•_ ERROR
Show if the
command is
supported
AT*E2NBTS=?
•_ *E2NBTS: (list of
supported <ch>s)
•_ ERROR
The set command shall provide with the ARFCNs (<ch>) and the BSIC (the
BSIC is a cell colour code) to the MS in order to monitor those channels,
belonging to the neighbour cells, instead of the ones that come through the
air interface, in the serving cell information broadcast channel.
It is possible to update that information with up to 16 neighbour cells. If less
than 16 <ch>s are provided, then the assigned channels shall substitute the
last previous channel (given either by the BCCH or by another AT*E2NBTS
command), if it is not in the list yet. Therefore, <ch1>,<bsic1> will
substitute BTS 16 in the MS, <ch2>,<bsic2> to the BTS 15 and so on. If any
of the <ch>s is already in the top-list, then it is skipped.
The read command displays the data of every neighbour cell, including the
following parameters: MCC, MNC, Cell ID, BSIC, Channel and Rx Level.
<ch> Description