Sony Ericsson TT4031 (SE-GM29) - Manual (Page 73)

Owner’s Manual Rev 1.0 Page 73 of 73
3.4 ATS3 Command Line Termination Character
Description Command Possible Responses
Set Command Line
Termination Character
ATS3=<value> •_ OK
•_ ERROR
Read the current setting ATS3? <value>
Show if the command is
supported
ATS3=? S3: (list of supported
<value>s)
This S-parameter represents the decimal IA5 value of the character
recognised by the DCE from the DTE to terminate an incoming command line.
It is also generated by the DCE as part of the header, trailer, and terminator
for result codes and information text, along with the S4 parameter.
The previous value of S3 is used to determine the command line termination
character for entry of the command line containing the S3 setting command.
However, the result code issued uses the value of S3 as set during the
processing of the command line. For example, if S3 was previously set to 13
and the command line “ATS3=30” is issued, the command line is terminated
with a <CR> character (IA5 0/13), but the result code issued uses the
character with the ordinal value 30 (IA5 2/14) in place of the <CR>.
<value> Description
13 Command line termination character, Default value
0 to 127 Command line termination character
3.5 ATS4 Response Formatting Character
Description Command Possible Responses
Set Response
Formatting Character
ATS4=<value> •_ OK
•_ ERROR
Read the current setting ATS4? <value>
Show if the command is
supported
ATS4=? S4: (list of supported
<value>s)