Sony Ericsson TT4031 (SE-GM29) User Manual
Page 204
Owner’s Manual
Rev 1.0
Page 204 of 204
]]]]
•_ ERROR
Shows the current
setting
AT+CNMI?
•_ +CNMI:
<mode>,<mt>,<bm>,<ds>
•_ OK
•_ ERROR
Show if the
command is
supported
AT+CNMI=?
•_ +CNMI:
(list of supported <mode>s),
(list of supported <mt>s),
(list of supported <bm>s),
(list of supported <ds>s)
•_ OK
•_ ERROR
Selects the procedure for the way in which new messages received from the
network, are indicated to the TE when it is active, e.g. DTR signal is ON. If
the TE is inactive (DTR signal is OFF), message receiving is carried out as
specified in GSM 03.38 (3G TS 23.038).
If the command fails and the error is related to mobile equipment or network,
the final result code CMS ERROR: <err> is returned.
<mode> Description
3
Forward unsolicited result codes directly to the TE. TA-TE
link specific inband technique used to embed result codes
and data when TA is in on-line data mode
<mt> Description
0
No SMS-DELIVER indications are routed to the TE.
No class, Class 0, class 1 and class 3 use <mem3> as
preferred storage. Class 2 messages shall be stored in
the SIM. If it this is not possible then the MS shall send
an error message accordingly to GSM 03.38
1
SMS-DELIVER is stored into ME/TA and the indication of
the memory location is routed to the TE using unsolicited
result code:
+CMTI: <mem>,<index>
2
Class 0, class 1, and class 3 SMS-DELIVERs are routed
directly to the TE using the unsolicited result code but not
stored in ME/TA:
+CMT:[<alpha >], <length><CR><LF><pdu> (PDU
mode enabled)
Class 2 data coding scheme result in indication as defined
in <mt>=1