Sony Ericsson TT4031 (SE-GM29) - Manual (Page 266)

Owner’s Manual Rev 1.0 Page 266 of 266
Description Command Possible Responses
Requests calling line
identification.
AT+CLIP=<n> OK
Read the current setting AT+CLIP? +CLIP: <n>,<m>
Show if the command is
supported
AT+CLIP=? +CLIP: (list of
supported <n>s)
This command enables a called subscriber to get the identity of the calling
line when receiving a mobile terminated call. The “Set” command enables or
disables the presentation of the CLI (calling line identity) at the TE. It has no
effect on the execution of the supplementary service CLIP in the network.
When the presentation of the CLI at the TE is enabled (if the calling
subscriber has allowed it), the unsolicited result code
+CLIP:<number>,<type>,,,<alpha> response is returned after every RING
(or +CRING:<type>) result code sent from TA to TE (refer to AT +CRC in
section ???????).Whether this will be used when a normal voice call is
answered is a manufacturer-specific option.
<n> Description
0 Disables presentation. Default value
1 Enables presentation
<m> Description
0 CLIP not provisioned
1 CLIP provisioned
2 Unknown (e.g. no network)
Unsolicited Result codes:
+CLIP: <number>, <type>,,,<alpha>
Defined values:
<number> Description
String Type phone number of format specified by <type> type
of address octet in integer format (refer to GSM 04.08,
sub-clause 10.5.4.7)