13 at+ilrr cable interface local rate reporting – Sony Ericsson TT4031 (SE-GM29) User Manual
Page 149
Owner’s Manual
Rev 1.0
Page 149 of 149
<by_te> Description
0
No flow control on DTE
1
Xon/Xoff flow control on DCE. Control characters are
removed by the DCE interface
2
RTS flow control on DCE. Default value
3
Xon/Xoff flow control on DCE. Control characters are
passed to the remote DCE/DTE
<by_ta> Description
0
No flow control on DCE
1
Xon/Xoff flow control on DTE
2
CTS flow control on DCE. Default value
10.13 AT+ILRR Cable Interface Local Rate Reporting
Description Command Possible
Responses
Defines DTE-DCE
character framing
AT+ILRR=<value>
•_ OK
•_ ERROR
Read the current setting AT+ILRR? +ILRR:<value>
Show if the command is
supported
AT+ILRR=?
+ILRR:(list of supported
<values>s)
Specifies whether or not the extended-format “+ILRR:<rate>” information
text is transmitted from the DCE to the DTE. The <rate> reported shall
represent the current (negotiated or renegotiated) DTE-DCE rate. If enabled,
the intermediate result code is transmitted after any modulation, error
control or data compression reports are transmitted, and before any final
result code (e.g. CONNECT) is transmitted. The <rate> is applied after the
final result code is transmitted.
<value> Description
0
Disables reporting of local port rate (+ILRR: is not
transmitted). Default value