Sony Ericsson TT4031 (SE-GM29) - Manual (Page 134)

Owner’s Manual Rev 1.0 Page 134 of 134
Fax
8.1 AT*E2FAX Ericsson M2M Fax Comm. Baud Rate
Modification
Description Command Possible Responses
Request change of fax
comm. baud rate
AT*E2FAX= <RcV>
•_ ERROR
•_ OK
Displays currently set
rate
AT*E2FAX?
•_ *E2FAX: <RcV>
•_ ERROR
Shows if the command
is supported
AT*E2FAX=?
•_ *E2FAX: (list of
supported <RcV>s)
•_ ERROR
This command allows the modification of the factory default RS232 comm.
setting between standard 9600 baud and 19200 baud. This is needed as the
addition of fax capabilities, within the module, require communication
between fax applications and the module to run at a higher baud rate than
the fax transmission baud rate (In this case the fastest transmission rate is
9600 baud). Once this command has been performed, the user must then
execute the AT&F command to reset the module with the new RS232 comm's
baud rate.
The AT*E2FAX command allows the user to:
“Configure” the RS232 Comm. speed default factory profile,
specifying whether the speed should be 9600 baud (standard) or
19200 baud for FAX application comm. This value will then be
used once the AT&F command is next used.
“Read” what value this default factory profile has been set to.
<RcV> Description
0 Configure RS232 default setting to 9600 baud
1 Configure RS232 default setting to 19200 baud
•_