User program configuration – Toshiba T2N User Manual
Page 154
2. User Program Configuration
User's manual
141
(14)
Computer Link Parameters
This sets and registers the parameters when using enhanced
communication functions (Computer link, Data link, Free ASCII
port). These parameters can be registered/monitored on the
system information screen of the programmer.
The parameter items and their setting limits are as follows.
i) Computer link, Free ASCII port
●
Station No.
... 1-32 (initial value = 1)
●
Baud rate (bps) ... 300, 600, 1200, 2400, 4800, 9600,
19200(initial value = 9600)
●
Parity
... None, odd, even (initial value = odd)
●
Data length(bits) ... 7,8 (initial value = 8)
●
Stop bit
... 1,2 (initial value = 1)
ii) Data link
●
Station No.
... 1 (initial value = 1)
: Master station
... 2 (-32)
: Slave station
(15)
Input/Output Allocation Information
This stores input/output allocation information and unit leading
address designation information. This information is created
either by executing the automatic I/O allocation command or by
setting and registering an I/O module type for each slot (manual I/
O allocation on the I/O allocation information screen of the
programmer.)
(16)
Network Assignment Information
Information on the link register areas allocated to data
transmission stations (TOSLINE-S20LP, TOSLINE-F10) and
information on the data input/output methods are stored here.
The network assignment information can be registered/monitored
on the network assignment information screen of the programmer.