Toshiba T2N - Manual (Page 8)

Introduction
- vii -
Markings used on the T2N and in this manual
Warning Mark on the T2N
This is the warning mark for dangerous location. It is attached to the equipment in
positions where there is a risk of electric shock and in positions where there is a risk
damage to the equipment through wrong wiring.
Take the following precautions where there is this mark.
(1) Keep hands away from terminals ,especially the input terminall of power supply while power on, to avoid
the risk of electrical shock.
(2) Turn off power before installing or removing modules, terminal blocks or wires.
(3) Applying excess power voltage to the T2N can cause explosion or fire. Apply power of the specified ratings
described in this manual.
Safety Label
!
The safety label as shown on the left is
attached to the power terminal of the T2N.
Remove the mount paper before wiring.
Peel off the label from the mount paper
and stick it near the power terminals
where it can be readily seen.
This mark is printed in places in this manual which should always be read carefully.
Read them carefully.
NOTE