Toshiba VF-nC1 - Manual (Page 117)

E6581090
K-5
11
• Operation mode parameters
Title Communication
No.
Function Unit
Minimum setting unit
Panel/
Communication
Adjustment range Default
setting
User
setting
Reference
H 0300 PWM carrier
frequency - - 0:2kHz
1:2kHz (Random
mode)
2:4kHz
3:4kHz (Random
mode)
4:8kHz（auto-reduction
mode）
5:12kHz (auto-
reduction mode)
6:16kHz (auto-
reduction mode)
5 6.9
H 0301 Auto-restart control
selection - - 0:Disabled
1:At auto-restart after
momentary stop
2:When turning ST-
CC on or off
3:At auto-restart after
momentary stop or
when turning ST-CC
on or off
0 6.10.1
H 0302 Regenerative power
ride-though control - - 0:Disabled
1:Enabled
2:Deceleration stop 0 6.10.2
H 0303 Retry selection
(Number of times) Times 1/1 0(OFF),1-10 0 6.10.3
H 0305 Over voltage limit
operation - - 0:Disabled
1:Enabled
2:Enabled (forced
shortened
deceleration)
0 6.10.4
H 0360 PI control - - 0: Disabled
1: Enabled 0 6.11
H 0362 Proportional (P) gain - 0.01/0.01 0.01-100.0 0.30 6.11
H 0363 Integral (I) gain - 0.01/0.01 0.01-100.0 0.20 6.11
• Torque boost parameters
Title Communication
No.
Function Unit
Minimum setting
unit Panel/
Communication
Adjustment range Default
setting
User
setting
Reference
H 0401 Slip frequency gain % 1/1 0-150 50 6.12.1
H 0409 Base frequency
voltage 1 V 1/0.1 50-500 *2 6.12.1
H 0415 Motor rated current A 0.1/0.1 0.1-50.0 *3 6.12.2
H 0416 Motor no-load current % 1/1 30-80 *3 6.12.2
H 0417 Motor rated speed min -1 1/1 100-12000 *2 6.12.2
H 0418 Speed control gain % 1/1 0-100 40 6.12.2
H 0419 Speed control stable
coefficient % 1/1 0-100 20 6.12.2
*2: The value is changed according to the set-up parameter condition.
(VFNC1 (S)-□□□□P□-W type)
FH:80, UL80, VL:60, F127:0, F170:60, F171:200, F204:80, F409:200, F417:1710 for VFNC1 (S)-□□□
□
P□ type.
*3: Parameter values vary depending on the capacity. Refer to page K-8.