Yamaha SU700 - Manual (Page 119)

Chapter 2 Tutorial 119
CHAPTER
2
●
Setting the effect depth and rate of change
5. When you press an EFFECT/[EFFECT 1]-[EFFECT 3] buttons, the effect type selected
for the corresponding button will be displayed.
▼ In the case of a system effect, the specified effect can be applied to all tracks. Turn
the knob of the track to which you wish to apply the effect, and specify the effect
depth for that track. You can strike the pad and hear the sound processed by the ef-
fect.
▼ In the case of an insertion effect, the effect will be applied only to the tracks to
which the effect was connected in step 2.
Use the MASTER track knob to make adjustments. It is not possible to adjust this in-
dependently for each track (sample). You can strike the pad and hear the sound pro-
cessed by the effect.
NOTE:
• In the screen that appears when you press an EFFECT/[EFFECT 1]-[EFFECT 3] buttons,
it is not possible to select the effect type or to modify parameters.
You can think of this screen as being a place where you set the send levels from each
track to three external effect units, EFFECT 1–3.
• If you press the EFFECT SETUP/[CLEAR 1]-[CLEAR 3] buttons, the effect send levels
will be set to 0 for each track that is using that effect. (
→
Effect clear 1/2/3: p.214)
6. If the selected effect type allows you to specify the resolution (cycle of change), the
NOTE area of the display will indicate “RESOLUTION=.”
▼ Press the [NOTE] button to make “RESOLUTION=” blink, and use the dial to
specify the desired note value symbol.
MEASURE
BPM
NOTE