Yamaha SU700 - Manual (Page 298)

Chapter 10 J
obs
298 Chapter 10 Jobs
10.3.8 SYSTEM Group
Use these jobs to set various system and MIDI parameters and to view remaining
sequence memory and sampling time.
What The Jobs Do
SETUP
Selects the ribbon function, and sets the metronome, the recording
countdown, the recording mode, the pad sensitivity, and the audio-input
type.
MIDI Sets the various MIDI parameters.
SCSI Sets SCSI IDs (local ID and remote ID).
MEMORY Shows remaining sample and sequence memory.
SYSTEM | SETUP
Use to: Make various system settings.
●
These settings are stored in nonvolatile memory, and are not lost at power-
off.
●
These settings are common to all songs.
●
Changes that you make on these screens become effective immediately.
●
The following jobs are available.
METRONOME Sets up the metronome.
COUNTDOWN Sets the countdown (number of lead-in measures) for song
recording.
REC MODE Selects the mode used to record songs (either “overdub” or
“replace”).
PAD SENS Sets pad velocity sensitivity on or off.
AUDIO IN Selects the audio input source.
RIBBON
FUNCTION
Selects the function to be controlled by the ribbon.
<METRONOME>
Use this job to set up operation of the metronome. The
CLICK parameter selects the
conditions under which metronome sound is produced, and the OUT parameter se-
lects the output destination for the metronome sound.
CLICK = OFF Metronome is always off. (No metronome click.) This is the
factory default setting.
REC Metronome click is produced only during song recording.
REC/PLAY Metronome click is produced during both song recording and
song playback.