Yamaha SU700 - Manual (Page 241)

Chapter 10 Jobs 241
CHAPTER
10
10.3.3 TRACK EDIT Group
Use these jobs to copy track data or event data from one track to another, or to reset
track data or event data on a selected track. You must select the appropriate song
before beginning to run these jobs.
What The Jobs Do
TRACK COPY Copies all non-event track data from one track to another.
TRACK INIT
Deletes all data on the track (the sample itself, event data, and non-
event data), and returns all track settings to their defaults.
EVENT COPY Copies all events (all sequence data) from one track to another.
EVENT INIT
Erases all events (all sequence data) on the selected track.
TRACK EDIT | TRACK COPY
Use to: Copy track content (sample waveform, sample parameters, and current
knob settings and mute setting) from one sample track into another
(within the same song).
●
The track you are copying from is called the source track. The track you are copy-
ing to is the destination track.
●
The destination track type need not match the source track type. You can copy
from any LOOP, COMPOSED LOOP, or FREE track to any other LOOP, COM-
POSED LOOP, or FREE track.
●
You cannot select the AUDIO IN or MASTER track for either the source or the
destination.
●
This job does not copy any of the source track’s recorded sequence data. To copy se-
quence data, use the TRACK EDIT | EVENT COPY job (
→
p.243).
●
Specifically, this job copies the following: the sample itself; the sample’s start-point
and end-point settings; the current SOUND, GROOVE, LFO, EQ, FILTER, and
EFFECT settings; the current mute state (ON or MUTE); and the TRACK SET job
settings for MAIN, FILTER TYPE, NOTE ASSIGN, OUTPUT TO, LFO WAVE, and
BPM TRACKING (the last one is copied only if source and destination tracks are
the same type).