Yamaha SU700 - Manual (Page 225)

Chapter 10 Jobs 225
CHAPTER
10
Page
SAMPLE: Edit/convert the waveform on the selected track. 259
START POINT Set the playback start point on the waveform.
END POINT Set the playback end point on the waveform.
PROCESS
TRIM Trim the waveform (remove unused parts at the ends of the waveform),
freeing up additional sample memory.
REVERSE Reverse the direction of the waveform (so sound goes “backwards”).
NORMALIZE Adjust the dynamic range of the waveform.
FREQ. CONVERT Reduce the waveform’s sampling frequency (freeing up additional waveform memory).
BIT CONVERT Reduce the waveform’s bit resolution (freeing up additional waveform memory).
STEREO TO MONO Convert stereo sample to mono (freeing up additional waveform memory).
DELETE Delete the sample (and all sequence data) from the selected track.
RESAMPLE: Record sample from already recorded track or song. 272
TRACK Resample from recorded track.
SEQ Resample from recorded song.
DISK: Load to disk, save from disk, and manage disks. 281
LOAD Load volume or sample from disk.
SAVE Save data to disk.
DELETE Delete volume from SCSI disk.
UTILITY
DISK INFO View amount of free memory on disk.
DISK FORMAT Format disk.
SYSTEM: Set system and MIDI parameters; check free memory. 298
SETUP
METRONOME Set up the metronome.
COUNTDOWN Set the number of lead-in measures for song recording.
REC MODE Set song recording mode to REPLACE or OVERDUB.
PAD SENS Set pad velocity sensitivity ON or OFF.
AUDIO IN Select the input source for audio input.
RIBBON FUNCTION Select the function controlled by the ribbon.
MIDI
SYNC Set the MIDI synchronization type for the current song.
CHANNELS Set the MIDI channel numbers for each track.
CONTROL NUMBERS Set the MIDI control numbers for each song.
SCSI Set remote and local SCSI IDs.
MEMORY Show remaining sequence or sampling.
10.2 General Procedure
To execute a job, you use the following general procedure.
1. Be sure that the sequencer is in PLAYBACK STANDBY or JOB mode.