Yamaha SU700 - Manual (Page 336)

A
ppendix
336 Effect Parameter List
D63>W,...,D_W,
...,D<W63
6: PITCH2 [PITCH CHANGE 2]
1 Fine 1 PITCH -50,...,+50 Fine pitch setting for first unit
2 Fine 2 FINE1 -50,...,+50 Fine pitch setting for second unit
3 Initial Delay INITDLY 0,...,127 Delay length
4 Feedback Level FBLEVEL -63,...,+63 Amount of feedback
5 Dry/Wet Balance DRY/WET Balance of the dry sound and effect sound
7: VCECNCL [VOICE CANCELLER]
1 Low Adjust LOW ADJ 0,...,26 Adjust the frequency of the lower limit of
the mid range that will be attenuated.
2 High Adjust HI ADJ 0,...,26 Adjust the frequency of the upper limit of
the mid range that will be attenuated.
8: AMBIENC [AMBIENCE]
1 Delay Time DLYTIME 0,...,127 Delay length
2 Wet Output Phase OUT_PHS Invert the phase of the effect sound be-
tween L/R
3 EQ Low Gain LOWGAIN -12,...,+12 Gain with which the EQ will boost/cut the
low range
4 EQ High Gain HI GAIN -12,...,+12 Gain with which the EQ will boost/cut the
high range
5 Dry/Wet Balance DRY/WET Balance of the dry sound and effect sound
9: LO RESO [LOW RESOLUTION]
1 Mod Depth MODDPTH 0,...,127 Modulation depth
2 Mode Delay Offset MODOFST 0,...,127 Modulation delay offset
3 Resolution RESOLTN 1, 1/2,...,1/264 Resolution
4 Phase Invert R PHASINV OFF, WET, Right channel phase reversal
WET+DRY
5 Dry/Wet Balance DRY/WET Balance between dry sound and effect
sound
10: NOISY [NOISY]
1 Drive DRIVE 0,...,127 Degree of distortion
2 Mod Depth MODDPTH 0,...,10 Modulation depth
3 LPF Cutoff Freq LPF FRQ 34,...,60 Frequency at which the low pass filter will
cut the high range
4 LPF Resonance LPF Q 10,...,120 Resonance of the low pass filter
5 Dry/Wet Balance DRY/WET Balance between the dry sound and effect
sound
D63>W,...,D_W,
...,D<W63
NORMAL,
INVERSE
D63>W,...,D_W,
...,D<W63
D63>W,...,D_W,
...,D<W63