Yamaha SU700 - Manual (Page 239)

Chapter 10 Jobs 239
CHAPTER
10
COMPOSED LOOP track: Sets the number of beats for the loop pattern (rhythm
pattern).
You can set the length from 1 to 128 beats. (The default is 4.) Once you have re-
corded a sequence of Note On events, however, the SU700 will not let you set the
loop length shorter than the beat at which the final Note On occurs. For example,
assume that you first set the length to 10 and then use the pad to produce a loop
that has its final Note On at beat 7. In this case you can shorten the loop length to
8 or 9, but you cannot shorten it to 7 unless you first delete the Note On that oc-
curs at beat 7. (You can delete Note On events using the JOB/NOTE DEL editing
function or the EVENT EDIT | LOCATION&VALUE job).
OUTPUT TO
OUT = STEREO OUT , AS 1 ,..., AS 6 , AS 1+2 , AS 3+4 , AS 5+6
[all tracks except AUDIO IN and MASTER]
The default is STEREO OUT.
This value sets the output destination of the selected track. This setting is available
only if you have installed the AIEB1 I/O expansion board. (If you have not installed
the board, the SU700 will not display the
OUT = setting screen.) You can direct the
output to the standard STEREO OUT jacks, to a single assignable output jack (AS1
to
AS6 ), or to an adjacent pair of assignable output jacks ( AS 1+2 , AS 3+4 , or AS
5+6 ).
●
If you direct output to a single jack (AS1 to AS6): The pan is fixed at the center
position, and pan control is ineffective. If the sample is stereo, the two channels
are mixed to produce monaural output.
●
If you direct output to a pair of jacks (AS 1+2, AS 3+4, or AS 5+6): Pan operates
normally. If the sample is stereo, the left channel goes to the lower-numbered
jack, and the right channel goes to the higher-numbered jack.