Yamaha SU700 - Manual (Page 84)

Chapter 2 T
utorial
84 Chapter 2 Tutorial
Recording on Other Free Tracks (FREE 2, 3, and 4)
Put the sequencer in recording mode, and press the pads for FREE tracks 2/3/4 at the
locations shown in the table below.
MEASURE
FREE Tracks
2 3 4
Section A 025:1
028:1
●
032:1 ●
032:4 ●
036:1 ●
040:1 ●
040:4 ●
Section B 041:1
044:1
●
048:1 ●
048:4 ●
052:1 ●
056:1 ●
056:3 ●
■ Building Sections C and D
In sections C and D, the LOOP tracks 1 and 2 are muted. FREE track 1 of track bank
2 will play continuously as in Intro A and B, and we will use FREE tracks 2/3/4 of
track bank 2 to record scratch actions.
Procedure
Recording on FREE 1 of track bank 2
1. Press the [MEASURE] button, and then turn the dial to set the location to 057:1 (the
beginning of section C).
▼ If the count-in has been turned off, select a location earlier than 057:1 (such as
055:1).
2. Press the button to put the sequencer in REC STANDBY mode. Then press to
begin recording.
3. Set “QUANTIZE= ,” and then press to begin recording.
4. When the location reaches 057:1, press and hold the FREE 1 pad of track bank 2.
Hold the pad down for 16 measures, releasing it at 072:4.
Recording Ribbon Actions on FREE 2, FREE 3, and FREE 4 of track bank 2
Proceed in the same way as you did when recording these tracks for the Intro A and Intro B
sections, and use the scratch function of the ribbon controller to record FREE tracks 2/3/4.