Yamaha SU700 - Manual (Page 323)

APPENDIX
Installing the Options 323
Remove the coverplate.
(Viewing from the rear.)
5. Installing the ASIB1 Board
1
2
The optional ASIB1 board (SCSI board) allows the SU700 to connect to external
SCSI storage devices such as hard drives and MO drives so that you can save and
reload large quantities of data quickly and conveniently.
NOTE: The SU700’s factory-default SCSI ID settings are as follows.
• SU700 SCSI ID: 6
• External device ID: 5
Preparation
1. Check that the ASIB1 board has both of its cables attached.
The board should have two bundled cables extending from it, as shown in the illustra-
tion above.
1 Flat cable, extending from rear center.
2 A red/white 2-wire cable.
2. If you have not yet done so, unfasten and lift off the top cover as described in “Flip-
ping the Cover” on page 314 above. Also be sure that you have a Phillips screwdriver
at hand.
Installation
1. Remove the two screws holding the small coverplate to the rear panel. Take the
coverplate out.
Keep the two screws handy; you will need them in a minute. You will not need the
coverplate again unless you decide to remove the board.