Yamaha SU700 - Manual (Page 321)

APPENDIX
Installing the Options 321
(Viewing from rear.)
(Viewing from rear.) (Viewing from rear.)
2. Fasten the board into the SU700.
Hold the board so that it fits against the open slot along the rear panel (where the
coverplate was). Fasten it to the rear panel by screwing in the three screws you re-
moved in Step 1.
3. Arrange the flat cable so that it passes through the vertical flap on the FD drive, and
connect the free end to the black 40-pin connector (“CN4”) located next to the FD
drive.
Pull the cable toward the front of the SU700, then fold it 90 degrees over and to the
left and pass it through the vertical plastic flap mounted on the top left of the FD drive
(viewing from the front of the SU700). Connect the end of the cable to the 40-pin
connector (“CN4”) on the main board. The connectors are notched to ensure that you
connect in the right direction.
Fold the cable gently, using a rounded fold. Do not press down strongly to get a sharp
fold, as this may damage the internal wiring.
Fold cable over. Please cable into flap,
and connect end to
40-pin connector.