Yamaha SU700 - Manual (Page 83)

Chapter 2 Tutorial 83
CHAPTER
2
■ Building Sections A and B
Now we will record FREE tracks 1–4 of track bank 1 for sections A and B.
We will play the sample on FREE track 1 at the beginning of each section.
For the other FREE tracks (FREE 2, 3, 4), you can strike pads to record notes (pad
presses) at any locations you like while listening to the playback from the other
tracks.
●
Since the FREE track pads are velocity-sensitive, the force with which you strike
the pads can be used to change the volume or record other types of data. If you
wish to record each strike at the same volume, turn off the pad sensitivity. (
→
p.301: PADSENS)
●
The [UNDO/REDO] button can also be used when recording the FREE tracks.
Procedure
Recording on FREE 1 of track bank 1
1. Press the [MEASURE] button, and then turn the dial to set the location to 025:1.
NOTE:
If you are not using any lead-in, you may want to set the location to one or two measures
before 025:1, so you have adequate lead-time to prepare to enter pad and knob action.
2. Press the button to put the sequencer in REC STANDBY mode.
3. Set the quantize interval to quarter-note (QUANTIZE= ), and press to begin
recording.
4. When the location reaches 025:1, press and hold the FREE 1 pad of track bank 1.
Continue holding the pad until 026:2.
▼ At the location 041:1 once again press the FREE 1 pad, and hold it until 042:2. This
completes the recording for this track.