Appendix – Yamaha SU700 User Manual
Page 322
Advertising
A
ppendix
322
Installing the Options
Clamp
(Viewing from rear.)
4.
Connect the free end of the 3-wire cable to the 3-pin connector (“CN6”) on the
brown board.
5.
Connect the free end of the 4-wire cable to the 4-pin connector (“CN5”) on the
brown board, and pass the cable through the clamp mounted on the corner of the FD
drive.
Open the clamp, set the cable inside it, and then close it so that it snaps shut.
6.
If you are finished with installation, replace and refasten the cover, as described in
“Closing the Cover” on page 315 above.
NOTE:
Once the board is installed, the SU700 should display the message IO BOARD FOUND
each time it starts up.
Advertising