Yamaha SU700 - Manual (Page 318)

A
ppendix
318 Installing the Options
(2)
2. Insert the remaining SIMM into the remaining socket.
Again, set the SIMM into the socket at an angle (with the cutout facing down and to-
ward the rear), and then push it upright so that it locks into place.
NOTE:
If for some reason you should need to remove a SIMM from its socket:
Hold open the two hooks on the socket (one at each end) and push on the SIMM so that
it moves in the opposite angle from that shown in Figure (2) above. Then pull the SIMM
out.
3. SIMM installation is now completed.
If you moved a previously installed AIEB1 board out of the way to gain access to the
sockets, move it back into position and refasten it now. (See Step 3 on the preceding
page.)
If you need to install a new AIEB1 board or an ASIB1 board, refer to the appropriate
procedure on the following pages.
If you are finished with installation, replace and refasten the cover, as described in
“Closing the Cover” on page 315 above.
Push upright.