Yamaha SU700 - Manual (Page 325)

APPENDIX
Installing the Options 325
(Viewing from rear.)
(Viewing from rear.)
4. Fasten the board into the SU700.
Hold the board so that its SCSI connector fits through the open slot along the rear
panel (where the coverplate was). Fasten the board to the rear panel by screwing in the
two screws you removed in Step 1.
5. Arrange the flat cable so that it passes through the nearest plastic fastener on the FD
drive.
You want to arrange the cable so that it moves over and then under the fastener on its
way from the ASIB1 board to the SU700 connector. The fastener keeps the cable firmly
in place so that it can not interfere with the SU700 internals. (Note that if you also
install an AIEB1 board, then the flat cable from that board will also pass through this
fastener-underneath the flat cable from the ASIB1 board.)
6. Be sure that the TERM switch (termination switch) on the ASIB1 board is set to ON.
NOTE:
When you connect up a SCSI device, you must also set that device’s terminator ON. (If
connecting up multiple devices, you must switch on the terminator for the final device
in the chain.)
7. Replace and refasten the cover, as described in “Closing the Cover” on page 315
above.
NOTE:
Once the board is installed, the SU700 should display the message SCSI BOARD
FOUND each time it starts up.